RUBSHILD PROTECT

PRODUCT INFORMATION:

• Film Composition:
• Solvent : Water
• Binder : Acrylic Emulsion
• Color : As per Rubguard Catalogue

Coverage : On smooth surface 55 to 60 sq feet per liter for 2 coats and on rough/high Porous Surface 35 to 55 sq feet liter for 2 coats. The coverage figures are theoretical and due to wastage factors and variety and nature of possible substrates, practical coverage figures may be reduced.

• Finish : Smooth
• Volatile Organic Compound (VOC) : Low VOC
• Performance in White and Bases : Shades vary depending on colorant used
• Glows/Sheen Level : Available in Medium Sheen
• Stability of Thinned Paint : Recommended to use within 24 hrs. of Mixing thinner
• Thinner : Water
• Flash Point : Non-Flash as per IS 101/1987
• Packing Size : Available in 1,4,10 and 20 liters
• Shelf Life : 3 Years for the date of Manufacturing in original sealed condition

APPLICATION INFORMATION:

It is advisable to read the safety, health and environmental regulations prier to the following application method.

• Tools of Application : Conveniently applicable with paint Brush or roller.
• Surface Preparation : Fresh Masonry surface should be cured properly and completely before application. It is strongly recommended to allow minimum 10 to 12 weeks for curing new masonry surface. Make sure that surface has been cleaned properly and is dry and free from all raw cement, chalk, grease, loose dirt, grease, fungi, algae and any loose old paint if any by means of wire brush/ stiff coir brush followed by jet spray machine if and wherever required.

Also, for severely damaged surfaces, fill up all minor cracks and defects with Rub Crack Seal. For major cracks, use cement and sand mixture in ratio 1:3 along with Rub Crack Seal. For optimum results surface preparation plays vital role. Rubshield Protect is not recommended to be used on surfaces which are exposed to continuous water seepage and dampness.

Primer application (If Applicable):

For ultimate and long-lasting protective life, it is highly recommended to use Rub Base Coat Acrylic Emulsion primer instead of using any other primer. Primer can be diluted with water in 1:1 volume ratio.

Dilution : For light shade, dilute 1 Liter of Rubshield Protect with 425-475 ml of water for application. For Dark Shade, dilute 1 Liter of Rubshield Protect with 325-425 ml of water for application.

Coating : For optimum results, apply 2-3 coats/ layers of Rubshield Protect over Rub Bas Coat- Acrylic Emulsion primer.

Drying Time (For Single coat) :

• Touch Dry : 30 Minutes
• Further coating/ Re coat: 5-6 Hours

Drying time depends on the temperature and humidity at the time of application. For example, drying time is longer in cool and humid seasons

Cleaning: Clean all application tools and other equipment with water after use.

SAFETY, HEALTH AND ENVIRONMENT INFORMATION:

• Bucket must be kept in a secure, upright position and closed tightly.
• In case of contact with eyes, immediately wash with a plenty of water and seek medical assistance if required.
• It does not contain any Lead, Mercury or chromium compounds.
• In case of contact with skin, wash immediately with plenty of water and soap.
• Lead Contains does not exceed with 100 PPM in dried paint.
• On request, safety data sheet can be supplied for professional users.
• It is recommended to use suitable personal protection equipment.
• Remove as much as possible paint from brush or roller before cleaning.
• Don't empty in to drainages. Dispose of container and contents as per local rules and regulations.
• Don't use empty container for storage of food.

PRECAUTIONS :

• Stir well before use.
• Do not apply during rain and wet weather.
• Do not apply at temperature of below 10 C